The BT-210 is a product that uses Bluetooth communication to enable serial communication (UART).

The BT-210 covers the circuit with a case to protect it, and it uses a connector-type cable to install on a robot and RC-100B. 

You can control your robot without any problems even when the infrared control condition is not optimal such as in a robot competition.

The SLAVE module can be used when controlling the robot from a device that supports Bluetooth communication such as a smartphone, tablet PC or notebook.

Controller : CM-530 (Wireless control, wireless download possible)

             CM-510, CM-700 (Wireless control possible (firmware update required))

Remote Control : RC-100B

The MASTER module and the SLAVE module are divided – MASTER module for the transmitter; SLAVE module for the robot.

When first released and purchased, the two modules are paired so there is no need for a separate ID setting procedure. If either of the components is lost, you will have to purchase the BT-210 (Product code 902-0076-000) for pairing.

Directions for pairing can be found in our e-Manual.

Click to refer to directions for pairing

The initial Pin Code when released from factory is 0000. Use this when connecting to the Bluetooth device(SLAVE). When a change is needed, please refer to the link above. However, OpenCM-9.04-A or C type controller is required. 

Installation Not Supported

-Remote Control : RC-100, RC-100A

-Controller : CM-100, CM-5, CM-2+